Several weeks ago, my 96 SeaDoo SPi wouldn't even turn over. I did some investigation and discovered that the 5amp fuse had blow. Replacing the fuse and trying to start the SPi only resulted in another blown fuse. Reading the manual suggested that this was probably due to a bad starter solenoid. So, I replaced the solenoid and everything was great... had a fun day on the lake and then put the SPi back on the lift.
One week goes by, I get ready to have some SPi fun but no go... won't even turn over. I get into the electrical box and the fuse is again blown; but this time when I replace the fuse, it blows immediately... I don't even have to try to start the SPi.
Any ideas about where I should look for the problem?