Thread: Exhaust Mod
08-10-2010, 09:44 PM #1
Just did my exhaust mod on my FZR and it was maybe 30 minutes. Removed the small silencer and relplaced with PVC endcap, cut 3 1/2 inches off the one tube going into the larger silencer and clamped it. It sounds the same but dont know if under load it would be louder. Hard to believe this would help performance. Modded VX plate from Jim is on, Ribbon removed, R&D grate w/seal. Riva intake is next.
67 mph (GPS) in florida heat in bath water, 3/4 tank, and 275 lb driver with no mods. Hopefully 70 with all listed above. This is addicting.
08-11-2010, 09:39 AM #2
- Join Date
- Mar 2009
I do not think taking off small baffle will do much. good luck
08-11-2010, 12:45 PM #3
So you did the Tommy Jordan FZ exhaust mod? Is that what you did?
08-11-2010, 06:56 PM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Vern in forum 4-Tec PerformanceReplies: 31Last Post: 03-03-2009, 06:58 PM
By rx4pain in forum 4-Tec PerformanceReplies: 11Last Post: 03-04-2008, 10:43 PM
By rxpdoo in forum 4-Tec PerformanceReplies: 0Last Post: 11-14-2006, 05:07 PM
By DeeGee in forum 4-Tec PerformanceReplies: 2Last Post: 06-19-2006, 07:56 PM
By DeeGee in forum 4-Tec PerformanceReplies: 17Last Post: 06-19-2006, 04:11 PM