Results 1 to 5 of 5
  1. #1

    odi grips on qts

    did a search cannot find how to put odi grips on the qts...also what size would i need to go over the qts...thanks in advance

  2. #2

  3. #3

  4. #4
    Steach the qts size grip is 90mm correct?...and that will fit around the plastic on the qts? I have been looking for that size at various site's and cannot find them...any suggestions. thanks for all your responses and also steach that is a sweet job on your gpr

  5. #5
    Moderator beerdart's Avatar
    Join Date
    Aug 2006
    You use 7/8" grips and cut the stock plastic piece off and adapt the new plastic insert to the old one. Or if you only want the thumb part of the trim to turn just cut the grip shorter.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. ODI Grips on Stock RXP/RXT bars
    By 550ss in forum Sea Doo How To & FAQs
    Replies: 23
    Last Post: 04-19-2015, 07:10 PM
  2. What size ODI grip on QTS grip assembly?
    By Ski Hacks MG in forum Yamaha PWC Performance (4-stroke)
    Replies: 7
    Last Post: 01-19-2015, 09:28 PM
  3. ODI grips on Stock RXP
    By 550ss in forum Sea Doo How To & FAQs
    Replies: 0
    Last Post: 04-13-2014, 08:27 PM
  4. ODI grips on a QSTS
    By ou812 in forum Yamaha Open Discussion
    Replies: 15
    Last Post: 11-15-2009, 06:52 AM
  5. Thanks Duke and BeerDart- ODI grips on stock trim
    By OsideBill in forum Yamaha PWC Performance (2-stroke)
    Replies: 25
    Last Post: 06-26-2008, 07:32 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts