Thread: xs intercooler set up
08-11-2010, 08:53 PM #1
xs intercooler set up
i have a xs .ebay (fizzle) type intercooler set up with the bleed mod.....includes all piping.. couplers..band clamps..bracket...and fittings...as well as a greddy bov......charger tube is 2 3/4 and the tb tube is 3 you will still need te stock intercooler block off
looking for 300 +shipping
i own a race car fabrication shop so i made the kit..i run a rear exhaust and dont have opas ..
still in my ski..ran it last weekend..and will until i have time to make the new set up..it is in good condition ..solid ok for off shore...just made a new pipe for the charger side...the old one had deformed little ...hence why it is still silver..
huge chargers..have higher exit temps..running a rude 3 17 psi ..in the fla 97 deg heat with the water temps running 90 to 93..i need to upgrade to a big money one.....
if you purchase it i will have to pull it from my ski so it may take a day or 2..
the heat exchanger bracket isnt included..
08-13-2010, 06:56 PM #2
bump for the weekend
08-20-2010, 05:55 PM #3
lots of inqiries ....pulling it this weekend...
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Hydrotherapy in forum Yamaha PWC Performance (2-stroke)Replies: 0Last Post: 04-30-2007, 03:06 PM
By 4-techscharger in forum 4-Tec PerformanceReplies: 6Last Post: 05-07-2006, 02:16 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 5Last Post: 04-09-2006, 06:25 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 46Last Post: 11-28-2005, 02:46 PM
By Jrsrxp in forum 4-Tec PerformanceReplies: 31Last Post: 07-22-2005, 03:37 PM