Thread: Converting to Premix
08-18-2010, 09:54 AM #1
Converting to Premix
I am trying to understand this.. I know there are caps and plates online to convert to premix, but are they really needed?
Can I just cap the line that goes to the oil tank and call it a day?
Do I really need to remove the oil injector pump and cap it?
08-18-2010, 10:25 AM #2
If you really wanna ditch the injection system, which is accually reliable.
You need to take off the pump, take off the oil pump spline from the mag, install oil pump again, cap the oil lines off, and then run a 40:1 mix.
08-18-2010, 12:41 PM #3
08-18-2010, 12:57 PM #4
rotary valve oil must be intact, so you have to keep oil in the tank and keep some oil, block line going to the pump, then same process!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By 450warrior in forum Polaris ProjectsReplies: 29Last Post: 06-08-2008, 11:33 PM
By rocky.ca in forum 2-Stroke PerformanceReplies: 4Last Post: 03-06-2008, 09:29 PM
By stingray152003 in forum Open DiscussionReplies: 7Last Post: 02-25-2008, 10:14 AM
By Yellow93 in forum Yamaha PWC Performance (2-stroke)Replies: 12Last Post: 10-11-2007, 10:37 PM
By Yellow93 in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 08-16-2007, 04:41 PM