Thread: alignement after pump wedge!!
08-19-2010, 08:27 PM #1
alignement after pump wedge!!
I'm basicaly having a hard time with the stering ajustment part.
When I'm installing the stering extention included in the kit, even with extension and ajuster screwed all the way in, the cable become too long to get nozzle and handle bars straight, so the nozzle is pointing to the left.
And if I don't use the extension the cable is too short, only 2 threads are grabbing (not enough) for a proper alignement.
What should I do??
08-19-2010, 08:29 PM #2
08-19-2010, 08:30 PM #3
There is another adjustment at the bar end.
08-19-2010, 08:31 PM #4
Do you have the two longer bolts that came with the wedge for the bottom? If not then it wont work.
08-19-2010, 08:37 PM #5
The cable housing adjustment up front will take care of all your problems! Loosen up the two 10mm hex bolts that secure the nut, and adjust the housing nut as needed... then tighten up the 10mm bolts. But first... screw your adapter & ball joint on the cable as far as possible, then adjust the cable housing.
08-19-2010, 08:47 PM #6
WOW!! Those were ultra fast answers!
08-20-2010, 02:24 PM #7
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By wavejunkie in forum Yamaha PWC Performance (2-stroke)Replies: 0Last Post: 05-27-2008, 05:20 PM
By Bone1050 in forum Polaris Open DiscussionReplies: 19Last Post: 10-03-2007, 01:21 AM
By wavehummer in forum Sea Doo Open DiscussionReplies: 3Last Post: 06-06-2007, 08:27 PM
By venompwr2 in forum Sea Doo Sport BoatsReplies: 7Last Post: 05-30-2007, 12:08 AM
By Angelse68cal in forum 4-Tec PerformanceReplies: 1Last Post: 08-25-2005, 07:58 PM