Thread: DESS POST replacement
08-22-2010, 02:20 PM #1
DESS POST replacement
I was wondering if this is a fairly easy task & for those who have performed the replacement, did you use solder for the wire connections or standard electrical crimp connector & heat shrink tube.??
08-22-2010, 07:10 PM #2
08-23-2010, 09:26 AM #3
It's pretty simple, it's part of the start/stop switch and the buzzer speaker harness. You can disconnect it at the harness so your not cutting anything.
08-23-2010, 12:55 PM #4
- Join Date
- Aug 2010
- Evesham, NJ
For my fix, I soldered the wires together and then used heat-shrink tubing on each individual wire, but I wanted to be sure they were protected. Probably a bit overkill..
Whole fix took me maybe 30 minutes.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Pistonwash in forum Yamaha PWC Performance (2-stroke)Replies: 36Last Post: 04-07-2010, 07:50 PM
By 1stskiguy in forum Sea Doo Sport BoatsReplies: 1Last Post: 05-16-2008, 10:35 PM
By cbrich in forum Sea Doo Open DiscussionReplies: 14Last Post: 04-05-2008, 10:02 AM
By RxPrider in forum 4-Tec PerformanceReplies: 4Last Post: 09-01-2007, 08:25 PM
By superduty in forum Sea Doo Open DiscussionReplies: 5Last Post: 08-14-2006, 01:16 PM