08-26-2010, 12:24 PM #1
rxp rearair without flowrites? any one not put in flowrites with their rear air?
Hey huys I just did a diy 4in rear intake and I don't have any flowrites. Are they a must have with a rear air?
08-26-2010, 01:09 PM #2
Do you mean in the cowl or the grab handle ? The cowl one is just to handle heat better.
08-26-2010, 01:23 PM #3
They are not a must have but they dont hurt for sure. Here is a look at mine.
08-26-2010, 02:51 PM #4
here's why im asking....the air enters the engine compartment via the hole in front of the seat under the glove box. and exits from the rear under the grab bar. so with the rear air now taking up the only exit for the hull heat. will this cause excessive heat soak to the engine?
also is the small hole in the grab handle large enough to not starve the SC?
08-26-2010, 05:21 PM #5
I would put them in..Like you stated,Air enters the front but has no were to escape the engine bay....I actually have 4 in my seat cowl along with a bilge blower in the front to help force the warm air out of the engine bay...As far as the grab handle holes??I have 2,2 inch diameter holes in mine with zero issues..
08-26-2010, 05:51 PM #6
They are just a good way to help with heat fade.
The cooler that engine bay is the better your are!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By rxpdoo in forum 4-Tec PerformanceReplies: 8Last Post: 08-19-2007, 10:55 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 5Last Post: 02-16-2007, 07:28 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 0Last Post: 12-07-2006, 05:10 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 12Last Post: 11-06-2006, 08:26 PM
By RXP'in in MI in forum 4-Tec PerformanceReplies: 31Last Post: 09-15-2006, 08:19 AM