Thread: Kawasaki 900zxi question
08-28-2010, 06:07 PM #1
- Join Date
- May 2010
Kawasaki 900zxi question
What connects the drive shaft to the back of the engine?What Im asking is what keeps the two pieces from coming aprart? I bought this ski with no engine in it,Installed everything but cant figure out what makes the driveshaft stay connected with engine....
09-01-2010, 08:06 PM #2
You have a driveshaft with the coupling half, right? There is a coupling half on the back of the engine that engages the teeth on the driveshaft coupling. There is a rubber disk that goes between them so you don't have metal-to-metal contact. You have to use shims to adjust the engine position to properly align the coupling pieces.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jarcynvicnchris93 in forum Kawasaki Open DiscussionReplies: 0Last Post: 06-17-2008, 11:16 PM
By kawiultra99 in forum Kawasaki PWC Performance (2-stroke)Replies: 5Last Post: 06-04-2008, 08:24 AM
By jarcynvicnchris93 in forum Kawasaki Open DiscussionReplies: 5Last Post: 04-22-2008, 07:35 PM
By 2k7rxp in forum Kawasaki PWC Performance (2-stroke)Replies: 8Last Post: 03-12-2008, 05:10 PM
By MTRHEAD in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 12-10-2006, 09:18 PM