Thread: RXP motor mounts
08-29-2010, 06:35 PM #1
RXP motor mounts
Still looking for my water problem. I am looking at motor mounts, because you guys listed that as maybe a problem. Should the back two mounts look the same?? The right side is at an angle and the left is straight. I am talking about the inside of the mount, looks like rubber maybe.
08-29-2010, 06:38 PM #2
The left and right rear mounts are the same.
08-29-2010, 06:51 PM #3
Stand on the right side of your ski, and pull up on the exhaust manifold, if the engine moves at all your mount is bad.
08-30-2010, 12:15 AM #4
I am saying right side while setting on the ski. The exhaust manifold is on the left. The motor mount that looks different is on the right. Looks bent to me.
PS. Will post a pic tomorrow.
08-30-2010, 12:38 AM #5
- Join Date
- Aug 2009
- Discovery Bay, CA
08-30-2010, 10:30 AM #6
I cannot move the engine at all. Here is a pic of the right side mount. The middle section with the writing on it is not straight up and down. Has a major slant to it. Is that normal??
08-30-2010, 10:54 AM #7
Yes, the rear mounts are both 'canted' due to the V shape of the hull where they are mounted.
08-30-2010, 03:41 PM #8
Even if it was a single motor mount thats not going to make your ski sink instantly. The only thing you can do is take the seat off and go for a high speed ride if it doesnt seem to be taking on water just idling around
08-30-2010, 05:20 PM #9
08-30-2010, 07:15 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By KEYZBUM in forum Polaris ClassifiedsReplies: 6Last Post: 06-20-2008, 12:00 AM
By Lvnspeed in forum Conversion Skis ClassifiedsReplies: 5Last Post: 05-16-2008, 03:08 PM
By BGslugger10 in forum 2-Stroke PerformanceReplies: 0Last Post: 05-01-2008, 10:32 AM
By scgolfer88 in forum 2-Stroke PerformanceReplies: 1Last Post: 11-17-2007, 07:27 AM
By Pale Rider in forum 4-Tec PerformanceReplies: 9Last Post: 06-10-2007, 07:09 AM