08-30-2010, 02:39 PM #1
Can you bypass the Oil Pump on an SL 700
I have done this on My Fuji engine skis, but is it ok to do it on the domestics? I guess my question is, can you remove the pump and block it off?
08-30-2010, 07:47 PM #2
08-30-2010, 09:59 PM #3
- Join Date
- Jul 2007
- near Toronto, Canada
Of course you can.
Remove pump, install block off plate with gasket.
Cap off carb oil fittings. Cap off oil tank.
If Low Oil display occurs, install 33 ohm resistor to ground inside electrical box in place of oil sender wire.
08-31-2010, 07:44 AM #4
Thanks. I did not know if because it was on the front of the crack case it made a difference
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By mac5900 in forum Polaris How To & FAQsReplies: 5Last Post: 05-04-2008, 05:11 PM
By Luisdeleon in forum Yamaha Open DiscussionReplies: 0Last Post: 10-25-2007, 12:49 PM
By schmitty in forum Kawasaki How To & FAQsReplies: 4Last Post: 09-10-2007, 06:58 PM
By Haislip in forum Sea Doo Open DiscussionReplies: 7Last Post: 07-27-2006, 01:19 PM
By theantiRXP in forum Sea Doo How To & FAQsReplies: 2Last Post: 06-25-2005, 12:20 PM