08-30-2010, 06:05 PM #1
xp 99/98 951 one cylinder not working
98 xp with a 99 951 engine in it.
Works good out of the water, once in water back cylinder (PTO) not firing....it has spar, and it looks like it has fuel (when I pulled the plug it looks wet). The compression on the engine is 120ps in both. Initially when I start the sky out of the water PTO side cylinder will not fire until its revved up. Second set of plugs and same issue. Any ideas on what it might be, or where to go next?
08-30-2010, 07:49 PM #2
- Join Date
- May 2008
- Elephant Butte New Mexico
have you had a look at the reeds?..sounds like an unhappy one.
08-30-2010, 10:06 PM #3
08-31-2010, 07:08 AM #4
sounds exactly like a stuck pop off, or WAY to much fuel on that cylinder.
08-31-2010, 07:36 AM #5
08-31-2010, 07:47 AM #6
08-31-2010, 07:18 PM #7
08-31-2010, 08:08 PM #8
09-01-2010, 01:55 AM #9
Your pto coil. lead or cap has failed that's if like you say it isn't firing. And this is a 99 engine in a 98 correct?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By eman in forum 2-Stroke PerformanceReplies: 2Last Post: 06-29-2008, 10:45 PM
By doc212121 in forum 4-Tec PerformanceReplies: 9Last Post: 05-01-2007, 08:41 PM
By boataddict in forum Sea Doo Open DiscussionReplies: 4Last Post: 07-09-2006, 10:33 PM
By jack in forum Sea Doo Open DiscussionReplies: 11Last Post: 06-25-2005, 08:25 PM