10-21-2006, 07:25 PM #1
How To Install R&D Pump Tunnell Reinforcement
Hi Guys how lucky am I just took delivery of the R&D Reinforcement Kit won it of EBAY it came with the glue but no instruction.
It s not rocket science but do you put the glue for the reinforcement between the hull and kit or just around the Pump Shoe bolt area.
What holds the Kit in place do i have to use epoxy glue or something can not find a install procedure on here maybe someone has a link.
10-21-2006, 07:31 PM #2
lucky bastard, i was gonna bid on that too!
you can allways give r&d a call....
10-21-2006, 08:54 PM #3
I tryed email them you think I got a reply even when i said I am in Australia and email would be the best way to send some info out.
10-22-2006, 05:08 PM #4
I am sure someone has installed one off these
10-22-2006, 06:02 PM #5
10-22-2006, 07:07 PM #6
i took and ground some of the extra factory glue took out old inserts and drilled a hole from bottom up 5200 the sh3T out of it new inserts make sure you counter sink hole for inserts. also a heavy rubber mallot is useful some grinding around cables
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By OsideBill in forum Yamaha How To & FAQsReplies: 133Last Post: 08-01-2016, 04:18 PM
By K-Dubb in forum Yamaha How To & FAQsReplies: 4Last Post: 04-24-2011, 09:59 PM
By nizzit in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 09-16-2009, 10:27 PM
By OsideBill in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 02-21-2008, 01:09 AM
By picaflor in forum Yamaha How To & FAQsReplies: 8Last Post: 05-18-2007, 01:02 AM