Thread: Need help before i give shop ok!
09-08-2010, 03:28 PM #1
Need help before i give shop ok!
2005 rxp.how hard is it to replace the pto seals, Do i need special tools, I was a ford tech for 7 years so im pretty mechanically inclined. Its the pics i have circled. Thanks in advance for help
09-08-2010, 08:57 PM #2
The rubber boot and bearing you have circled at the left is not hard at all. Remove pump and driveshaft(that can be tricky without correct tools) to replace. I am doing that myself this weekend. The other is attached to the crankshaft. Not sure if that can be unscrewed without removing the engine. Maybe someone else can chime in. Why does that coupler have to be changed?
09-12-2010, 12:00 PM #3
i dont think its the whole coupler i think iys just the seal to the left of the coupler. Thanks for the quick reply
09-12-2010, 12:04 PM #4
09-12-2010, 02:43 PM #5
09-17-2010, 01:42 PM #6
09-18-2010, 09:31 AM #7
- Join Date
- Jun 2005
- rome ga
Why replace the part in the engine you will be lucky to get it off the crank.
You will need a tool to get the driveshaft clip out.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By chritopherlloyd in forum Yamaha Old School SkisReplies: 21Last Post: 05-03-2008, 03:00 PM
By Jolly Roger in forum Yamaha PWC Performance (2-stroke)Replies: 11Last Post: 09-25-2007, 06:12 PM
By Dark_viper42 in forum Sea Doo Open DiscussionReplies: 2Last Post: 05-30-2007, 08:08 AM
By mudd in forum Polaris Open DiscussionReplies: 18Last Post: 02-12-2007, 07:28 PM
By rx4pain in forum 4-Tec PerformanceReplies: 13Last Post: 05-07-2005, 10:23 AM