Results 1 to 5 of 5
  1. #1
    seadoo dude uk's Avatar
    Join Date
    Sep 2010
    Location
    Lincoln UK England
    Posts
    4

    Help on how to install/fit a seadoo wake towing bracket to GTX 4-tec

    Hi every one, Great site with some great advice on here! This is my first thread and if poss would like some help. I have a 03 gtx 4-tec sc and wish to install the genuine seadoo adjustable tow bracket.I have bought a used bracket from a 155 gtx 4-tec wake addition and wondered if there was a template availible for cutting the big hole under the rear grab handle!! If not some install pictures or measurements would be a help. I'm guessing if you bought the part direct from seadoo it would come with a template for the cutting, does any one have one or know where I could get hold of/buy one please?

    Any help would be great

    Many thanks


  2. #2
    jpeconsult's Avatar
    Join Date
    Jul 2007
    Location
    Pineville, LA
    Posts
    5,448
    +1
    1
    I think it should be pretty straight forward. Line it up, mark the holes and drill. You may consider taping the gelcoat where you will be drilling to prevent cracking.

    Someone that has done this will chime in and welcome to the forum, bud. --Jeremy

  3. #3
    Welcome to the board.

    I have a ski pylon installed. Dealer did it for me though. Like's been said...should be able to set in place...mark holes...then you could make your own template from the bottom of the pylon and then set the template in place for the center mark.

    A key might be maintaining the centerline axis of the holes.

  4. #4
    seadoo dude uk's Avatar
    Join Date
    Sep 2010
    Location
    Lincoln UK England
    Posts
    4
    Thanks guys, it looks to hard for guess work, its hard to just line up as a big section of the pole goes inside the hull! I have got hold of the guy who I bought it off and he is going to do me a template so fingers crossed should have it installed soon

  5. #5
    idoodou's Avatar
    Join Date
    Mar 2009
    Location
    cincy,ohio
    Posts
    765
    +1
    30
    have someone print off the brp instruction for installing ski plyon follow them to the letter and it well be all good

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Help on how to run a new engine!!
    By luvrotax in forum Polaris How To & FAQs
    Replies: 3
    Last Post: 07-19-2014, 11:11 AM
  2. oil cable jammed need help on how to unjam it
    By kyle5647 in forum Yamaha How To & FAQs
    Replies: 0
    Last Post: 06-25-2013, 01:09 PM
  3. Please help on how to replace tps sensor and trim cble
    By tonyp1986 in forum Yamaha PWC Performance (2-stroke)
    Replies: 2
    Last Post: 09-21-2012, 02:37 PM
  4. Need help on how to post on seadoo classifies!!
    By sam712 in forum 4-Tec Performance
    Replies: 0
    Last Post: 09-17-2012, 01:51 PM
  5. Guys Need help on how to get the Washer Mod Done!
    By MonsterEnergy in forum Kawasaki PWC Performance (4-stroke)
    Replies: 8
    Last Post: 05-30-2011, 01:41 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •