Results 1 to 2 of 2
  1. #1
    shhr's Avatar
    Join Date
    May 2005

    R&D block & 3 Bar sensor

    Hey guys anything wrong with using the extra port on the R&D block for my vacuum line on the 3 bar map sensor I do not want to lose the block as I dont want to tap another hole in the manifold if possible (lazy). I would simply unplug the 2 bar leave it in place and install the 3 bar on the firewall with the vac line coming from the R&D block

  2. #2
    SHOBiz's Avatar
    Join Date
    Jul 2008
    Wylie, Texas
    I don't see why not. I just bought some precut stock from online metals (not cheap) and made my own block.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. FS: GPR R&D grate single bar
    By MTRHEAD in forum Yamaha Classifieds
    Replies: 1
    Last Post: 07-18-2008, 01:46 PM
  2. Air/Fuel guage & sensor
    By lafjax in forum 4-Tec Performance
    Replies: 10
    Last Post: 05-09-2008, 06:33 PM
  3. riva pro block off vs r&e block off
    By yellow jacket in forum 4-Tec Performance
    Replies: 2
    Last Post: 05-18-2007, 07:50 PM
  4. report on r&d two bar grate and hole filler
    By txgp1300r in forum Yamaha Open Discussion
    Replies: 4
    Last Post: 05-14-2006, 08:50 PM
  5. Latch & Knock Sensor Recall
    By rxp_boy in forum 4-Tec Performance
    Replies: 4
    Last Post: 06-01-2005, 04:01 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts