Page 1 of 11 1 2 3 ... LastLast
Results 1 to 10 of 109
  1. #1

    Join Date
    Jul 2007
    Location
    PDX - Oregon
    Posts
    2,205

    Rxp-x / RXP / 4 Tec parts for sale- Ongoing- check back often for new items

    ALL PARTS ARE FRESHWATER ----NO JUNK-

    The OEM P-X parts have 64 hours on them. After market parts have 0-64 hours on them.

    Please EMAIL me [email protected] with parts inquiries


    See pictures of all parts here-- https://picasaweb.google.com/1080968...eat=directlink

    PTO cover with sensors, drive shaft bearing, oil filter lid/bolt, and stator. Rubber boot that holds bearing was cut down to fit a bearing carrier FYI- $300.00


    Intake manifold with f/a removed, Les Cooke fogging system and Riva block off and the one sensor – 200.00


    Skat bearing carrier/drive shaft seal- comes with a rebuild kit that includes bearing, seals and silicone coupler. Custom extension for easy greasing. T-bolt clamps. Does not need a rebuild- low hours and always greased- $175.00



    Front hood with chrome trim, latch, orange storage cover. Garmin forerunner GPS mounted just above latch for perfect viewing. No mirrors. Holes are there for round dynotune gauges. $350.00

    Chrome side vents w/hardware- $75.00

    OEM valve retainers- $50.00


    Oil pumps front and rear complete- $100.00

    VTS - $175

    Starter $150.00

    All 3 OEM motor mounts with shims $100.00

    Water pump cover with thermo- $50.00

    Orange grab handle- $35.00



    OEM Intercooler form PX- -- I backed the water up in this thing and it swole at the front- one time incident. Has been used since and pressure tested with both air and water- does not leak. $200.00

    OEM PX 87 MM nozzle with sterring nozzle. No VTS ring. $50.00

    Steering nozzle with trim ring- $30.00 Used


    Seat with Jet Trim hump seat cover, black and silver -- various materials from non-slip to carbon- $240.00

    VTS- Extension rod, older style ---aluminum, only diff. is color, came straight from Riva. $75.00

    REFERENCES AVAILABLE UPON REQUEST



    GUYS/GALS-- I WON'T TAKE PAYPAL DUE TO A RECENT 3K HOLD ON MY FUNDS WITHOUT GOOD REASON. SO MUCH SO THAT IT TOOK BETWEEN ME, MY CONGRESSMAN, SENATORS, ATTORNEY GENERAL, AND MY ATTORNEY TO GET MY MONEY INSTANTLY

    ANYTHING I CAN DO TO RE-ASSURE PEOPLE I WILL DO... I KNOW FROM EVERYONE TONIGHT IT'S BEEN MORE OF A TIME ISSUE THAN A "I DON'T TRUST YOU" ISSUE.

    ONE EXCEPTION IS FOR LARGE ONE ITEM PURCHASES, LIKE THE MOTOR I HAVE FOR SALE. MY FINACE' HAS A PAYPAL ACCOUNT AND I CAN TALK ABOUT USING THAT UNDER CERTAIN CONDITIONS.

    BOTTOM LINE PAYPAL IS NOT REGULATED BY THE BANKING SYSTEM AND THEREFORE AT ANY MOMENT YOU CAN GET SCRWED.

    I'VE SEEN PEOPLE SAY "GIFT ME THE MONEY TO AVOID THE FEES'" THIS ALONE GOT MY ACCOUNT FLAGGED QUICKLY.

    LIKE I SAID -- WOSRT CASE GIVE ME A CALL AND WE CAN TRY TO MAKE EVERYONE FEEL GOOD ABOUT THE DEAL. I'VE BEEN AROUND HERE FOR A COUPLE YEARS AND A LOT OF YOU KNOW MY NAME.

    Email me for a phone number -- [email protected] , or a PM.. email is preferred though.
    Last edited by pdxrealtor; 05-20-2011 at 08:56 PM. Reason: Add more parts for sale


  2. #2

    Join Date
    Jul 2007
    Location
    PDX - Oregon
    Posts
    2,205
    PREVIOUSLY SOLD---


    Throttle Body- $150.00 SOLD


    60lb Bosch injectors- three- flow matched with the papers- installed never used-$150.00 SOLD


    Exhaust manifold tapped for o2 sensor- $150.00 SOLD

    08 Head Pipe Assembly-- 85.00 comes with clamp, no burnt ends- get rid of your J-pipe. SOLD

    Complete wiring harness including fuel rail, voltage regulator, relay, gauge harness etc. Basically if it could be unplugged from the sensor/part etc it’s included. $300.00 SOLD

    Solas 15/20 bent by Speedfreeks, set back mod by SKAT, new R/D short nose cone- $240- SOLD

    Oil cooler- $75.00 SOLD


    Gauge cluster with chrome bezel – great condition- 260.00 SOLD

    3 coil packs- 125.00 SOLD

    Billet open loop cooling cover and reducer that comes off the head- $60.00 SOLD

    Riva catch can with bracket and bolts- $50.00 SOLD

    Rear exit exhaust, Riva- $50.00 SOLD

    4” Fizzle intake w/ R&D 4” adaptor- $125 SOLD

    Piranha solid front motor mount- installed, never ran- $100.00 SOLD

    Solid billet pump cone with 3 rings to fine tune take offs/cavitation. SOLD

    3 Billet prop nose cones- 15.00 each SOLD


    Riva 2* pump wedge and VTS Extension Rod- $150.00 Wedge is new in packaging (opened)-- Extension rod is older style aluminum, only diff. is color, came straight from Riva. Will not separate. SOLD



    Riva Thermostat- $100.00 - new- installed - never usedSOLD


    Seadoo Centre ECU for 8650 RPMs- $600.00 SOLD

    Engine Tech B-kit upgrade. Fully assembled- very close to E/T Extreme specs. 3" spacer. Never used. OEM 08 shaft kit with Riva washers and McMaster spring washers. Slip at 205 in/lbs using a rolling torque wrench Comes with 4" billet adapter seen in picture-never used. -- $1100.00 NEW SOLD

    Bag of OEM spring washers (17 I think), 3 sets of OEM 08 gold washers, 1 08 gear, 2 L washers, McMaster washers (around 7) low hours (less than 20) on all. $50.00 - mostly usedSOLD


    Solas 15/22 (newer model- came as 15/22 from Solas) $290.00 ]Brand New Never Used- Setback mod similar to speedfreeks, but done by Glen at SKAT. R/D short billet blue nose cone. Will fit newer and older style pumps. SOLD

    Adjustable nozzle with extra rings- 81-87 mm - $300.00 - Used SOLD


    Reverse bucket, shaved mod, with hardware. $65.00 SOLD

    Riva pump extension with balanced and blue printed SKAT pump. Machined lower pump lip to locate prop blades closer to pump vanes (must have set back prop for this mod). Extension kit is new never used. Pump has 0 hours since it's been to SKAT and been inspected. $1150.00 SOLD


    Riva Intercooler RELO kit complete. Comes with T-bolts and new silicone couplers and original silicone couplers. ---$350.00 SOLD

    Dyno Tune Gauges- 1 brand new boost- round/blue --125.00 SOLD

    " " 1 brand new TEMP gauge- round/blue ---- $150.00 SOLD

    " " 1 brand new LC1 kit- round/blue --- All gauges are out of box and have been installed but not wired up. ---$225.00 SOLD

    JD1 Pump Pressure Relief Valve w/jig for installation- 300.00 - brand new---- SOLD

    Walbro Fuel pump - $80.00 - brand new SOLD

    Complete thru hull set up, OEM. Bellow, floating ring, carbon, clamps $100.00 - New SOLD

    Black Hydro Turf for P/PX boats- 60.00 SOLD

    1 OEM cover for PX/P. Slits where my longer aftermarket bars extend farther than stock. Great condition $65.00 SOLD

    Black grab handle with 2 flow rites- $100.00 NEW SOLD

    Complete glove box assembly with no broken hinges. Liquid boost gauge installed on lid. $50.00 -USED Good shape SOLD

    1 OEM drive shaft- great condition- 64 hours- $75.00 SOLD

    Jet Trim large splash guard- 40.00 NEWSOLD
    Last edited by pdxrealtor; 05-20-2011 at 08:57 PM.

  3. #3

    Join Date
    Jul 2007
    Location
    PDX - Oregon
    Posts
    2,205
    ..............
    Last edited by pdxrealtor; 03-15-2011 at 03:02 PM.

  4. #4

    Join Date
    Jul 2007
    Location
    PDX - Oregon
    Posts
    2,205
    ......................
    Last edited by pdxrealtor; 03-15-2011 at 02:24 PM.

  5. #5

    Join Date
    Jul 2007
    Location
    PDX - Oregon
    Posts
    2,205
    ...................
    Last edited by pdxrealtor; 03-15-2011 at 02:25 PM.

  6. #6
    How much for everything?

  7. #7

    Join Date
    Jul 2007
    Location
    PDX - Oregon
    Posts
    2,205
    PM sent

  8. #8

    Join Date
    Jul 2007
    Location
    PDX - Oregon
    Posts
    2,205
    ............................
    Last edited by pdxrealtor; 03-15-2011 at 02:25 PM.

  9. #9
    urdripn gomzi4629's Avatar
    Join Date
    Jan 2009
    Location
    syd aus
    Posts
    198
    pm sent

  10. #10

    Join Date
    Jul 2007
    Location
    PDX - Oregon
    Posts
    2,205
    Ttt

    Sent from my T-Mobile G2 using Tapatalk

Page 1 of 11 1 2 3 ... LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. FS RXP and GTX Parts for Sale
    By thompsdw in forum Sea Doo Classifieds
    Replies: 3
    Last Post: 10-30-2009, 04:05 PM
  2. FS: 4-TEC Parts for RXP/RXT/GTX
    By camar0 in forum Sea Doo Classifieds
    Replies: 59
    Last Post: 08-21-2009, 07:00 PM
  3. 4-TEC Parts for sale - RXP/RXT/GTX
    By camar0 in forum Sea Doo Classifieds
    Replies: 25
    Last Post: 08-07-2009, 01:11 PM
  4. 2004 RXP Hull and Parts for Sale
    By RX951 in forum Sea Doo Classifieds
    Replies: 11
    Last Post: 01-17-2009, 12:15 PM
  5. 4 Tec parts for sale! RXT RXP
    By BlackHawk in forum Sea Doo Classifieds
    Replies: 25
    Last Post: 10-12-2008, 01:57 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •