10-16-2010, 05:51 PM #1
- Join Date
- Oct 2010
Drive shaft removal help wont come out!!!
I'm having problems removing the drive shaft out of an 06 sportster with a 4-tec 215hp any tips, do you need to remove the bellow, carbon ring, and support ring and how.
10-16-2010, 06:43 PM #2
- Join Date
- Aug 2009
- Discovery Bay, CA
Yikes tons of rust thats gonna make it hard. Yes slide the boot/bellow back amd there is a c clip you have to pop off the driveshaft, that will allow you to pull the shaft out. Do a search on carbon ring replacement and there are some tricks to make it "easyier"
10-16-2010, 06:51 PM #3
Welcome to the forum!
Put the pump back on with a spacer down in prop. Then just snug the pump up, do not over tighten.
Then do as stated above.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Franko in forum 4-Tec PerformanceReplies: 3Last Post: 08-05-2007, 12:48 AM
By Franko in forum 4-Tec PerformanceReplies: 3Last Post: 07-18-2007, 12:11 PM
By twinstack1 in forum Kawasaki Tech Tips and InfoReplies: 0Last Post: 06-21-2007, 10:30 AM
By WannabeGoing80 in forum 4-Tec PerformanceReplies: 0Last Post: 12-16-2006, 12:48 PM
By JAG in forum 4-Tec PerformanceReplies: 11Last Post: 10-28-2006, 11:08 AM