Results 1 to 6 of 6
  1. #1

    Join Date
    Jun 2005
    Location
    near detroit michigan
    Posts
    299

    porting the pump?

    what gains would come from this?
    HOLE SHOT? top speed?
    I am in the process of simply smothing out all the casting and I am intersted in knowing what good this is going to do.
    (It is going to take a while lots of patients)


  2. #2
    Site Admin Green Hulk's Avatar
    Join Date
    Apr 2005
    Location
    Morgan City, LA
    Posts
    34,980
    +1
    1,898
    Some people say it does absolutely nothing. I plan on doing mine though when i get some down time. It sure can't hurt.

  3. #3
    EZ Dock of Long Island Shibby1485's Avatar
    Join Date
    May 2005
    Location
    Long Island, NY
    Posts
    9,466
    +1
    3
    what about salt water riders.... porting and smoothing and grinding it down a little will remove some of the anodized finish.... what could one use on this to protect against rust/corrosion?

  4. #4
    Nonstop, all day, everyday. 01xdime's Avatar
    Join Date
    Aug 2005
    Location
    Pasadena, MD
    Posts
    3,682
    it's be nice to port it out and then have it media blasted and powdercoated.

  5. #5
    Site Admin Green Hulk's Avatar
    Join Date
    Apr 2005
    Location
    Morgan City, LA
    Posts
    34,980
    +1
    1,898
    I would like to have mine extrude honed.

  6. #6
    JD 1's Avatar
    Join Date
    Aug 2005
    Location
    St. Louis, MO
    Posts
    4,185
    +1
    88
    Did nothing for me

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Polishing the pump
    By Green Hulk in forum Yamaha PWC Performance (2-stroke)
    Replies: 40
    Last Post: 07-28-2006, 10:11 AM
  2. I took off the pump for the first time.....
    By boataddict in forum Sea Doo Open Discussion
    Replies: 23
    Last Post: 02-17-2006, 09:45 PM
  3. While the pump is out.................
    By BULLRAIDER in forum Yamaha PWC Performance (2-stroke)
    Replies: 11
    Last Post: 02-06-2006, 09:40 AM
  4. How much clearance in the pump?
    By 818RXP in forum 4-Tec Performance
    Replies: 0
    Last Post: 08-07-2005, 04:53 PM
  5. Are sharks plastic fins in the pump support needed
    By macattack in forum 4-Tec Performance
    Replies: 0
    Last Post: 07-04-2005, 11:50 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •