Thread: my rude 1
10-23-2010, 12:44 AM #1
my rude 1
i have a rude one that has a little movement on the shaft..so if i grab the shaft from the back it has a little play...is that normal??
10-25-2010, 09:41 PM #2
10-25-2010, 09:43 PM #3
You about to Drop in an ET140R LE ???
10-25-2010, 09:51 PM #4
- Join Date
- Aug 2009
- Discovery Bay, CA
front to back movement right? i gotta 137 wheel that does the same fresh off a rebuild from jerry. mine is what i would consider barely noticeable but its there. zero up and down movement
10-25-2010, 10:35 PM #5
im is moving up and down?what does this mean?
10-26-2010, 09:38 AM #6
Do you know how many hours the bearings have on them? the bearings have some movement but not alot. if you are unsure how many hours they have I would replace them. It is easier to replace bearings in the s/c than to clean aluminum from the i/c and intake.
10-27-2010, 04:50 AM #7
10-27-2010, 09:20 AM #8
10-27-2010, 09:26 AM #9
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By pwc guru in forum Sea Doo ClassifiedsReplies: 10Last Post: 07-09-2008, 11:36 AM
By mjds257 in forum 4-Tec PerformanceReplies: 13Last Post: 07-04-2008, 07:35 AM
By gnatsum743 in forum 4-Tec PerformanceReplies: 24Last Post: 06-18-2008, 10:49 PM
By RXTMAN in forum Sea Doo ClassifiedsReplies: 10Last Post: 05-12-2008, 03:34 AM
By SCiD in forum 4-Tec PerformanceReplies: 8Last Post: 11-30-2007, 09:50 AM