Thread: rxp wear ring question?
11-02-2010, 08:34 AM #1
rxp wear ring question?
hey all, just changing my wear ring (which fell out using the freezer method)
and am currently pressing the new wear ring in. its going in fine but in all my excitement of removing my first wear ring, i didnt pay particular attention as to how far i press the wear ring into the pump
I assuming the wear ring should sit flush with rubber around the pump...
but obviously i want to be certain, as i dont want to press it to far ( if that s possible )
any tips would be great appreciated
thanks again guys
11-02-2010, 08:38 AM #2
Just tap in until it stops. You cannot drive it past the bottom lip.
11-02-2010, 09:07 AM #3
11-02-2010, 11:19 AM #4
- Join Date
- Aug 2010
- Slidell, LA
If you freeze the new wear ring, It will fall into place with out any hammering.
11-03-2010, 12:20 AM #5
11-03-2010, 02:45 AM #6
thanks for your tips guys... all installed , no probs.... now comes the supercharger...
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By lee in forum 4-Tec PerformanceReplies: 2Last Post: 10-08-2007, 10:40 PM
By speedy in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 04-27-2007, 08:51 PM
By qbzonk in forum Yamaha Open DiscussionReplies: 2Last Post: 04-24-2007, 07:11 AM
By NJ-Ski in forum Sea Doo Open DiscussionReplies: 8Last Post: 07-16-2006, 12:47 PM
By GeoRXT in forum 4-Tec PerformanceReplies: 14Last Post: 04-18-2006, 11:46 AM