Thread: Crank bearings
11-03-2010, 09:39 PM #1
For those of you who rebuild crankshafts...
How hard is it to get the PTO bearing (the one with the snap ring) on the crankshaft after it has been rebuilt. What I mean by this is...I have all the parts to rebuild my crank other than this one bearing. If I get the crank rebuilt without it, can I freeze the crank, heat the bearing and slide it on afterwards, or does it need a big press to put the bearing on?
11-04-2010, 06:56 AM #2
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By R88ory RXP in forum 4-Tec PerformanceReplies: 4Last Post: 07-04-2008, 09:34 AM
By ajrunke in forum 4-Tec PerformanceReplies: 10Last Post: 05-07-2008, 03:46 PM
By Taylor215 in forum Sea Doo Open DiscussionReplies: 1Last Post: 12-13-2007, 06:45 PM
By wavehummer in forum 4-Tec PerformanceReplies: 13Last Post: 09-06-2007, 01:31 PM
By SeaDoocer in forum 4-Tec PerformanceReplies: 8Last Post: 11-06-2006, 12:51 AM