11-04-2010, 06:08 PM #1
2004 rxp hull dilema on which motor and pump to buy
i have 3 options on the table
#1 - a 2008 rxt-x full set up
#2 - a 2007 rxt full set up
#3 - a 2005 rxp full set
what would you guys pick out of these three to install everything into a 2004 rxp hull, the hull is completely parted out so it has no tank , pump, electronics, gauges.
The only thing on the 2004 rxp hull is the steering with throttle and vts trim and start and stop switch as well as stock intake grate and stock rideplate.
let me know guys i trust you
11-04-2010, 06:12 PM #2
Go with the 08 and find a P driveshaft.
11-04-2010, 06:13 PM #3
Stay away from anything 06 and older. The 08 is going to make the most power.
11-04-2010, 07:42 PM #4
If you are replacing everything I would go 08 but the problem is that the T/Tx wiring harness wont work in a P/px but you could always just buy a 07+ p/px main harness brand new for around $300 I believe. Also, if you can you should do a compression test.
11-04-2010, 08:20 PM #5
11-04-2010, 08:22 PM #6
why do u say the wiring harness wont work its the same for all 4tec engines isnt it?
11-04-2010, 08:29 PM #7
the harness will work but its going to be longer so youll just have to be creative with the routing.
11-04-2010, 09:28 PM #8
11-04-2010, 09:37 PM #9
..2008 RXPX will be your best choice. Everything will fit perfect only for the steering handle bars mount bracket that will give you trouble but I think speedfreeks makes an adapter for it so it fits perfect......
11-05-2010, 12:31 PM #10
Rxt harness will work in rxp but you will need to extend the battery cables....
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By PiMPNXP in forum Sea Doo ClassifiedsReplies: 6Last Post: 08-11-2008, 12:51 AM
By spinyard in forum 4-Tec PerformanceReplies: 8Last Post: 07-15-2008, 02:17 PM
By chev-hell in forum Sea Doo ClassifiedsReplies: 12Last Post: 06-14-2008, 10:09 AM
By pbjones81 in forum Sea Doo ClassifiedsReplies: 2Last Post: 05-08-2008, 09:03 PM