Thread: Ok im getting warmed up!
11-20-2010, 12:02 PM #1
Ok im getting warmed up!
hmm, what all might I do??
11-20-2010, 12:08 PM #2
might aswell port & polish the head
11-20-2010, 12:09 PM #3
11-20-2010, 12:18 PM #4
No wait!!!!!, looks like he's about to remove the flame arrestor finally looking for that exra .01 mph!!!! It's either that or your gonna be testing the new intakes....
11-20-2010, 12:22 PM #5
11-20-2010, 12:24 PM #6
Port & polish heads, cams, re-balance crankshaft high compression pistons new rods... wings :=)
Have a great week-end
11-20-2010, 12:31 PM #7
back is starting to hurt. Good stopping point!
Well, Im pretty sure my head gasket is slightly blown so Im gonna pull the head and change that and prob upgrade my valves. If I get greedy might just pull the whole motor haha.
11-20-2010, 12:41 PM #8
What made you think the headgasket is slightly blown.
11-20-2010, 01:00 PM #9
11-20-2010, 01:12 PM #10
I am thinking mine might be slightly blown also. Last ride I lost some coolant. The oil is fine, but where, oh where did the coolant go. I am halfway tempted to bring it to WFO and just go ahead and replace the gasket and put a set of studs in. I am going out to ride next week so I will get the verdict then.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By ORL in forum 4-Tec PerformanceReplies: 7Last Post: 10-09-2007, 08:01 PM