Thread: Riva Rear Exhaust Template?????
11-23-2010, 05:08 AM #1
Riva Rear Exhaust Template?????
Just bought a riva rear exhaust for my p-x but it came with 2 sets of installation instructions for the 215 rxp rxt gtx, it says down the bottom of the page refer to 255hp booklet! My question is can i use the 215 rxp template? i printed off the 255 instructions from riva but for some reason its shrunk and dont want to rely on it!
11-23-2010, 06:42 AM #2
I think they are the same hull so the template should be the same.
When you drill the hole, duct tape the area and drill in reverse. It will give you a clean cut.
Don't drill the bolt holes off the template either, use the thru hull to mark the bolt holes. My bolt holes didn't line up to the template at all.
11-23-2010, 07:11 AM #3
The templates can be printed directly from the Riva site. Be sure to use the correct one (RXP vs RXT). The original one comes printed on both sides, one for each machine.
11-23-2010, 08:04 AM #4
I printed the rxpx 255hp instructions from the riva site, although it came out smaller than the original template. So dont want to rely on it. If its the same as the 215hp rxp template i can just use that?
11-23-2010, 09:20 AM #5
Cut the template out and put it up there. You will be able to tell if it is the same. I am 99 percent sure they are. Take a pic of it taped on there and someone can chime in. There are two templates from what I remember. 2 seater and 3 seater.
11-23-2010, 09:42 AM #6
11-23-2010, 06:43 PM #7
Thanks guys have printed another off and measured it and all seems sweet!
11-23-2010, 09:07 PM #8
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By mvanarchy in forum Sea Doo ClassifiedsReplies: 4Last Post: 07-05-2008, 02:49 PM
By lextoy in forum Sea Doo Open DiscussionReplies: 4Last Post: 04-21-2008, 10:40 PM
By camar0 in forum 4-Tec PerformanceReplies: 19Last Post: 12-04-2007, 08:14 PM
By JordanHaye in forum 4-Tec PerformanceReplies: 2Last Post: 06-06-2007, 07:45 PM
By LAB69 in forum 4-Tec PerformanceReplies: 3Last Post: 02-01-2007, 07:59 PM