Thread: Exhaust manifold 02 install
12-29-2010, 02:13 PM #1
- Join Date
- Jul 2007
- Montgomery, AL
Exhaust manifold 02 install
I know this has been beat to death but I am about to drill my 2005 manifold for the o2 sensor.
I am going to use the 12mm to 18 mm adapter that I purchased from innovate so I can drill a smaller hole to lessen the chance of hitting the water jacket.
My question is do I still drill the center of the boss area on the exhaust manifold? Not quite sure where the waterjacket is that I am trying to miss drilling into.
12-29-2010, 02:23 PM #2
12-29-2010, 04:13 PM #3
BD is it the same for the 14mm? Good question bro as i just pulled out my motor to do some upgrades,
12-29-2010, 04:14 PM #4
12-29-2010, 09:37 PM #5
12-29-2010, 09:52 PM #6
If your going to drill a smaller hole, and have extra room on the boss.... I personally would shift the hole as far away as you can from the water fitting!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By kepneriphone in forum Polaris Open DiscussionReplies: 6Last Post: 06-02-2008, 09:57 PM
By CableGuy in forum Sea Doo ClassifiedsReplies: 2Last Post: 04-26-2008, 08:48 AM
By North49 in forum 4-Tec PerformanceReplies: 9Last Post: 07-04-2007, 01:35 PM
By JCM in forum 4-Tec PerformanceReplies: 0Last Post: 02-20-2006, 05:26 PM
By nickdog in forum 4-Tec PerformanceReplies: 12Last Post: 01-17-2006, 10:39 PM