Thread: Heat Exchanger Brackets
11-16-2010, 05:55 PM #1
11-17-2010, 11:22 AM #2
I made a bracket that fits it behind the ICer right next to the tunnel...ill post a pic or two
Last edited by Snoman; 01-09-2011 at 06:32 PM.
11-28-2010, 09:29 AM #3
this how i did mine..it is a 40 plate i lined my bracket with a mouse pad to keep it from rubbing holes...this is 2 seprate intercooler set ups..and i ended up having to swapp to all brass fittings..you can see in the last pic.
01-06-2011, 04:09 PM #4
01-08-2011, 10:44 AM #5
I have the same water routing (HX, IC, exh with air bleed to pisser). I used the doo hoses where I could. In the gpr a flat plate fits on the transom bolts where the vts is in the doo(30 plate).
Last edited by steach; 01-09-2011 at 07:57 PM.
01-09-2011, 03:59 PM #6
- Join Date
- Aug 2007
- Sparrows Point, MD (near the Key Bridge)
Attachment 225865Attachment 225866Attachment 225867
My bracket, the IC sits on the top on a 45 like this / and is pinned against the foam in the rear. Plus the IC to TB pipe is resting on the 4" intake pipe. I was concerned for the first few rides, but after checking after running home in 2-3ft chop all was secure and tight so for the time being I feel its a ok setup.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By lemon1 in forum 2-Stroke PerformanceReplies: 1Last Post: 08-02-2008, 08:08 PM
By RobbieMWD in forum 4-Tec PerformanceReplies: 9Last Post: 08-01-2008, 11:46 PM
By Big George in forum Open DiscussionReplies: 2Last Post: 06-23-2008, 09:28 AM
By wolfking42084 in forum MSX/MatrixReplies: 3Last Post: 05-13-2008, 03:32 AM
By Danny in forum Conversion PWC Performance SkisReplies: 7Last Post: 03-14-2008, 02:37 PM