11-11-2006, 05:50 PM #1
Tripple Bearing mod by Skat (vertical movement?)
I flipped my pump over to remove the pump cone, and i hear a clunk ... i flip it back over again and the same... there's no side to side movement (that i'm aware of, the wear ring/prop tolerance is TIGHT so i wouldn't know if there's side to side play... but if i shake the pump in an up and down motion there's internal movement... very little! but most certainly movement since i can hear it click or clunking as i shake it.
what to do?
11-11-2006, 05:59 PM #2
you would think it wouldn't have any movement since a bearing should be secure in order to give any support or alignment. Since it's broken i'll give you $50 for it, LOL j/k.
11-11-2006, 06:13 PM #3
thats the center bearing moving back and forth between the two outer bearings. As long as you don't have any play in the shaft you are good to go.
11-11-2006, 06:18 PM #4
Dam Jerry you amazing!! LOL
11-11-2006, 06:37 PM #5
yea i was gonna say thats normal cause the 2 strokes i work on do the same thing
11-11-2006, 08:58 PM #6
niceeee, cool deal.
11-12-2006, 09:48 AM #7
I would try to measure how much, and let glen at skat know . I had the same issue with mine, and the bearings were moving,(also some side to side) which over time can wear out your pump housing. I sent it back, and he made the bearings press into the housing. I've had no movement at all since .
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By maildude in forum Sea Doo ClassifiedsReplies: 3Last Post: 06-16-2011, 10:26 PM
By IBADTON in forum 4-Tec PerformanceReplies: 3Last Post: 05-07-2009, 08:06 PM
By excess in forum 4-Tec PerformanceReplies: 10Last Post: 07-23-2006, 10:40 PM
By Sunfunzoom in forum 4-Tec PerformanceReplies: 24Last Post: 02-13-2006, 06:28 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 9Last Post: 08-12-2005, 07:03 AM