Thread: 2000 XP Handle Bar Conversion
11-12-2006, 04:01 AM #1
2000 XP Handle Bar Conversion
Guys wanting to replace my Handle bars finding them to narrow for my liking can i use a set off UMI Bars and keep my start stop button,trim control and what do you do with the choke and start ket plug.
Or is there a complete package or replacement kits available and who sells them.
This has me stuffed.
11-12-2006, 08:06 AM #2
- Join Date
- Feb 2006
- Warner Robins, GA Home of the 2007 All-Star Little League World Champions!
You can replace the bars with UMI, keeping the stock steering post. You have to relocate the DESS post, I'd eliminate the choke altogether and install a primer underneath the hood between the hood latches. Leave the bottom pod of the steering in place. It looks rough, but this is what alot of racers do.
11-14-2006, 04:35 AM #3
I just wedges up the whole steering 35mm used longer bolts at the rear then i just used some motorx bars, some adjusting and trimming (the cable mount and the cowl to clear the raised steering)
oh just look here
11-20-2006, 06:55 AM #4
I have a some ppg extended bars. 1 3/4" addd to each side. 60.00 shipped in the U.S. I have pics if you want.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By ctct2118 in forum Yamaha ClassifiedsReplies: 2Last Post: 07-15-2010, 12:28 AM
By ActionR32 in forum 4-Tec PerformanceReplies: 10Last Post: 04-08-2008, 05:58 PM
By the jetson in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 11-07-2007, 03:20 AM
By carlo in forum 4-Tec PerformanceReplies: 2Last Post: 03-13-2006, 10:44 AM
By sourpower RXT in forum 4-Tec PerformanceReplies: 4Last Post: 02-07-2006, 05:34 PM