02-11-2011, 04:32 PM #1
Best way to plum in my jd intercooler?
Hi all, what will be the best way to plum in my jd intercooler?.... i dont mind drilling one hole in the transom but i dont fancy drilling loads of holes or that.... i would like to use as much as poss of whats there already?
02-11-2011, 04:46 PM #2
02-11-2011, 04:48 PM #3
lol thanks for that! i need to use search more often
02-11-2011, 04:52 PM #4
02-11-2011, 04:56 PM #5
i must admit i do use it but i never seam to find what im looking for lol
that thread is good but dont explain where the feed is from... can i use my gay spray or should i fab up a plate for the strainer?
02-11-2011, 05:03 PM #6
come on Ian read a little
copied from the thread.......
The next step is to get the Riva high volume strainer that includes an additional outlet. This installs easily and you run a 1/2" hose from the strainer to the new thru-hull barb. It merely goes over the top of the pump and is approximately 18" long.
02-11-2011, 05:04 PM #7
i need my eyes tested i think!
(or cut down on the beer)
02-11-2011, 05:09 PM #8
02-11-2011, 05:13 PM #9
02-12-2011, 07:40 AM #10
Hi, had a good read of this now,
can i not use my pisser to put back through my hull? if i have to use the strainer can i not just tap the origional one thats there ?
also is the oem outlet ok to use where currently the outlet for the intercooler is?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By luismendez25 in forum 4-Tec PerformanceReplies: 30Last Post: 04-11-2007, 08:48 PM
By 4-techscharger in forum 4-Tec PerformanceReplies: 6Last Post: 05-07-2006, 02:16 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 5Last Post: 04-09-2006, 06:25 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 46Last Post: 11-28-2005, 02:46 PM
By Jrsrxp in forum 4-Tec PerformanceReplies: 31Last Post: 07-22-2005, 03:37 PM