Thread: Renthal bars on RXP ?????
03-11-2011, 11:08 AM #1
Renthal bars on RXP ?????
Will this work on my ski?
03-11-2011, 11:42 AM #2
I beleive so....
You will need to get the adapter for the throttle cable...
Yout will also need
Umi vts housing
And Some sheetmetal to make a des post bracket...
03-11-2011, 12:01 PM #3
if your interested we make a plate for the DSS post..... the plate also finishes off the front where the bolts are to gives a nice clean look: http://www.speedfreeksracing.com/sfr/products/11
03-11-2011, 02:35 PM #4
03-11-2011, 10:55 PM #5
I"m not sure.... According to the website it will...
You Will still need a throttle cable adapter...
Im Running a riva so I can not say if this will work or not....but, for 30 bucks...give it a shot....
03-11-2011, 11:35 PM #6
03-12-2011, 06:41 PM #7
Make sure with the finger throttle that you are getting WOT ..you may have to grind a bit off .
I have seen a few guys get caught out and when the TPS was checked on the SEADOO BUDS they where at 70% WOT ...
03-15-2011, 10:39 AM #8
03-15-2011, 11:45 AM #9
Yes, the Renthal bars work great on the RXP and are my favorite.
That throttle you are looking at I would be concerned with getting the proper rate of pull.
You can buy the Renthal bars in the forums online store
and use this throttle lever. It has the proper rate of pull for your ski with no hassles of cutting and grinding to make it work
this is the cable adapter that you will need
03-15-2011, 12:03 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By 007rxp in forum Sea Doo ClassifiedsReplies: 2Last Post: 01-04-2009, 02:14 PM
By spdracr in forum Yamaha ClassifiedsReplies: 5Last Post: 08-19-2008, 08:11 AM
By ActionR32 in forum 4-Tec PerformanceReplies: 10Last Post: 04-08-2008, 05:58 PM
By bzb in forum 4-Tec PerformanceReplies: 2Last Post: 02-13-2008, 04:24 PM
By Vman in forum Sea Doo Open DiscussionReplies: 2Last Post: 12-13-2007, 10:04 PM