Results 1 to 3 of 3

Thread: No RPM

  1. #1
    planiack's Avatar
    Join Date
    Apr 2009
    Location
    Punta Gorda
    Posts
    181

    No RPM

    I have a 2006 GTX wake board Edition. It is naturally aspirated. It had a check engine light with a 326 code. The ski would only go about 10 MPH. I checked the knock sensor and it was bad (only 1600k ohms and not about 5 meg ohms) I replaced the sensor. Now there is no check engine light but the ski now only gets to about 25 MPH which is about 5000RPM. Is there something that I have to do after replacing the sensor? Thanks.
    Mike


  2. #2
    Orlando Shark's Avatar
    Join Date
    Mar 2009
    Location
    Miami, FL
    Posts
    2,419
    +1
    10
    Are you using the right key? Not the learners key?

  3. #3
    planiack's Avatar
    Join Date
    Apr 2009
    Location
    Punta Gorda
    Posts
    181
    I am using the same key that I have been using. I have only one key for this ski.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. With MoTeC No Rpm
    By ad_gpr in forum Yamaha ECU Support
    Replies: 6
    Last Post: 05-19-2010, 10:12 PM
  2. XS IC no rpm Gain but lots of accelleration
    By turbojamie in forum 4-Tec Performance
    Replies: 35
    Last Post: 08-25-2008, 06:40 PM
  3. mfd no rpms
    By daza in forum Polaris Open Discussion
    Replies: 2
    Last Post: 10-03-2007, 10:00 PM
  4. VF3 Reeds yielded no RPM gain for me
    By MPower in forum Yamaha PWC Performance (2-stroke)
    Replies: 39
    Last Post: 06-04-2007, 02:17 PM
  5. Need help, No rpm's, not charging on mfd
    By gvnitup in forum Polaris Open Discussion
    Replies: 12
    Last Post: 05-22-2007, 12:13 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •