Thread: Block Guard for 4techs
03-29-2011, 01:12 PM #1
Block Guard for 4techs
what do you think about block guards,have you ever tested it?
the link is...http://www.4-tecperformance.com/inde...roducts_id=494
Cheers from Sunny Greece!
03-29-2011, 01:56 PM #2
Can´t see how it could preventing the sleeves from moving ?
Sorry for asking in your thread
03-29-2011, 02:30 PM #3
03-29-2011, 02:33 PM #4
These work great in high RPM/Power motors.
It prevents the sleeves from moving at high RPM. It closes the gap between the Cylinder walls and the rest of the block.
03-29-2011, 02:37 PM #5
So the block guard fits tight ? or said another way it must fit tight if it going to support the cylinder wall ? Pleace correct me if I´m wrong.
03-29-2011, 02:46 PM #6
03-29-2011, 02:58 PM #7
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Brad Clarke in forum 4-Tec PerformanceReplies: 3Last Post: 07-09-2008, 10:25 PM
By stickem in forum 4-Tec PerformanceReplies: 25Last Post: 07-05-2007, 10:56 PM
By earthshaker in forum Kawasaki PWC Performance (4-stroke)Replies: 0Last Post: 06-19-2007, 08:16 PM
By yellow jacket in forum 4-Tec PerformanceReplies: 2Last Post: 05-18-2007, 07:50 PM
By ramnj in forum Sea Doo Open DiscussionReplies: 32Last Post: 04-03-2006, 10:04 PM