11-17-2006, 09:52 PM #1
How does water get in the VTS box?
First time VTS owner... FINALLY.... i've ridden many skis with VTS, my first time OWNING a ski with VTS... i opened the cover... water inside
how does water get in there, how do i fix it? ... hopefully motor is still good or i'm screwed... wont know until i get the wiring harness and battery and ECU back in there
11-17-2006, 09:57 PM #2
If it is similar to a 1996 XP, mine began leaking at the rubber boot at the rear on my 1996 XP after about 3-4 years. It was a Very common problem amongst the older Doo's from the mid 90's
Here is a good article below.
11-17-2006, 10:01 PM #3
Last edited by Shibby1485; 11-18-2006 at 12:14 AM.
11-18-2006, 12:25 PM #4
- Join Date
- Jul 2006
- upstate NY
The rubber boots in the back ripp and ley water in the vts housing. Seadoo used Steel clamps that ripp the booy. Use zip ties when you repair it or the updated plastic clamps.
11-18-2006, 01:57 PM #5
ah ha ... u guys are the best. yea i checked it out, that rubber boot slipped out from under the rear clamp and it is eaten up a bit... i'm leaving the VTX black box open to let it thoroughly dry out and assume it's not locked up or shorted or anything.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By ercBOOSTED in forum Yamaha PWC Performance (4-stroke)Replies: 6Last Post: 09-02-2009, 07:23 AM
By NottaPhireMan in forum 4-Tec PerformanceReplies: 6Last Post: 07-21-2009, 11:06 AM
By lextoy in forum 4-Tec PerformanceReplies: 30Last Post: 11-01-2007, 10:43 PM
By turk0004 in forum Polaris How To & FAQsReplies: 8Last Post: 09-18-2007, 10:05 PM
By PuprleNuprleGPR in forum Yamaha PWC Performance (2-stroke)Replies: 9Last Post: 08-09-2006, 08:08 AM