Results 1 to 6 of 6
  1. #1
    BLACK MAGIC HEADERS hydrojunkie's Avatar
    Join Date
    Jun 2007
    Location
    new york
    Posts
    3,529
    +1
    3

    does anyone know how to test a rxp stator with an ohm meter

    i may have a bad stator, dont want to pull the motor out for no reason. rectifier is gettin 12 volts, volt meter say's 12.5 volts when ski is running so i know its not charging.


  2. #2
    BLACK MAGIC HEADERS hydrojunkie's Avatar
    Join Date
    Jun 2007
    Location
    new york
    Posts
    3,529
    +1
    3
    please help

  3. #3
    Got Boost? psycho rxp's Avatar
    Join Date
    Jul 2005
    Location
    Port St. Lucie, FL
    Posts
    5,445
    +1
    182

  4. #4
    Nothin' better than Doo'in it! BigDaddyRXP's Avatar
    Join Date
    Aug 2007
    Location
    Tampa Bay, FL
    Posts
    9,202
    +1
    673
    I didn't read that other thread... but there are 3 tests that you want to perform:

    1. Check resistance between all 3 yellow stator wires, unplug stator and check 1-2, 1-3, 2-3
    ohm readings should be between .1 - 1.0

    2. With the engine running, stator unplugged test the 3 wires in the same three sequences mentioned above.
    Set your meter for AC voltage, you should see 24 VAC on all three readings.

    3. Set your meter to ohms, and attach the ground lead to a solid engine ground.
    Check all three yellow wires for resistance to ground, there should be no resistance to ground.


    I just had a stator issue where test 1 & 2 were perfect, but I found all three windings shorted to ground.

  5. #5
    BLACK MAGIC HEADERS hydrojunkie's Avatar
    Join Date
    Jun 2007
    Location
    new york
    Posts
    3,529
    +1
    3
    the engine sat with loads of salt water in it. rebuilt entire engine bud never cheacked stator. 2 wires were corroded off it.

  6. #6
    5.0. alex_baker202's Avatar
    Join Date
    Aug 2007
    Location
    Lebanon, Missouri, United States
    Posts
    1,027
    +1
    24
    Just saw one in the classifieds for sale by suckmywake

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. does anyone know how to remove the exhaust tip that goes into the waterbox?
    By bscpaint in forum Yamaha PWC Performance (4-stroke)
    Replies: 13
    Last Post: 03-27-2016, 12:33 AM
  2. Does anyone know how to make older two-strokes more fuel efficient/quieter?
    By NorthShoreGuy in forum Yamaha Open Discussion
    Replies: 4
    Last Post: 10-07-2010, 11:23 PM
  3. Does anyone know how to make older two-strokes more fuel efficient/quieter?
    By NorthShoreGuy in forum Kawasaki Open Discussion
    Replies: 0
    Last Post: 10-06-2010, 09:00 PM
  4. Does anyone know how the engine break in on new RXP works?
    By dre23 in forum Sea Doo Open Discussion
    Replies: 17
    Last Post: 01-29-2006, 12:45 PM
  5. Anyone know how to shrink vids?????
    By two2curupt in forum 4-Tec Performance
    Replies: 5
    Last Post: 07-26-2005, 06:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •