04-12-2011, 10:35 PM #1
ported and completely/freshly rebuilt kawasaki small pin 750
This has been completely gone through by a local engine builder. There are new pro-x pistons, and new gaskets. The crank and bearings were inspected and given a clean bill of health. The cylinders were also ported and the portwork is top notch. See pics. The head was previously milled.
A lot of $$ went into this motor and I have receipts for everything! Id like to get $600 for it which just about covers the new parts and the labor of porting it.
This motor will absolutely rip in an X2. The stator housing was modified by the previous owner to accept X2 electrics, however it can easily be converted back. I had planned to use it but plans have changed. My loss is your gain as they say....
I also have a set of carbs and a manifold available fs separately.
04-12-2011, 10:48 PM #2
Note- my engine builder did get a little happy with the painting of the head. You can hit the nuts and the spout with a wire wheel.
04-13-2011, 08:06 AM #3
This motor was just finished. It carries a three month warranty against defects in pistons or workmanship.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By BigDaddyPT in forum Kawasaki How To & FAQsReplies: 3Last Post: 09-28-2008, 09:20 AM
By Big Tom in forum Polaris ProjectsReplies: 3Last Post: 07-11-2008, 08:38 PM
By jarcynvicnchris93 in forum Kawasaki Open DiscussionReplies: 0Last Post: 03-31-2008, 09:44 PM
By SRT_Boss in forum Kawasaki Open DiscussionReplies: 2Last Post: 08-07-2007, 07:07 PM
By Yellow04RXP in forum Kawasaki PWC Performance (2-stroke)Replies: 1Last Post: 06-02-2007, 08:23 PM