11-22-2006, 04:58 PM #1
2001 GPR R&D power plenum Jetting ???
I have a buddies 2001 GPR and redoing his carbs. He is running the power plenum on it. Does anyone have the jetting specs for this setup? He has a protec head on it running around 150 psi. Currently he has 117.5 main, 95 pilot (low speed), 95 gram spring and 1.2 n/s. Accelerator pump is still on the carbs and working.
If anybody has the correct jetting specs for this can you please post it up?
thanks in advance,
11-23-2006, 12:27 PM #2
anybody? Dave if you read this, call R&D up and ask them what their jet specs are with the accelerator pump. Your motor is back together, sealed up, pressure tested and ready to drop in. I'd like to get it done by Sunday,
11-23-2006, 10:29 PM #3
Don't have specs for that FA but that sounds scary lean!
I hate to post post on a thread that I don't have experience with
but thats my 2 cents.
11-28-2006, 07:10 AM #4
95 gram spring
1.5 needle and seat.
Start lows at about 1,1/8th out.
Highs out about 1,1/2.
It will start and run fairly well with the above settings, just dial in from there with a tach.
The above assumes your dissabling the pos accelarator pump!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By MJE in forum Yamaha ClassifiedsReplies: 10Last Post: 12-07-2012, 03:26 PM
By WFO in forum Yamaha ClassifiedsReplies: 2Last Post: 03-23-2010, 01:21 PM
By DrewNJ in forum Yamaha ClassifiedsReplies: 11Last Post: 09-27-2009, 08:46 PM
By patrick webb in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 07-19-2009, 12:40 AM
By stifun in forum Yamaha PWC Performance (2-stroke)Replies: 22Last Post: 05-14-2008, 10:05 PM