Results 1 to 6 of 6
  1. #1
    GTLaser's Avatar
    Join Date
    Aug 2009
    Location
    MD
    Posts
    330

    How to re-install PTO seal?

    I am pulling my motor and am at the point of removing the drive shaft but it seems to be seized to the PTO seal. Any tips on how to get this thing loose without ripping it out? Also for those who have removed the shaft, do you have to use the PTO seal support tool?

    Thanks!
    Last edited by GTLaser; 05-04-2011 at 07:42 AM.


  2. #2
    Got Boost? psycho rxp's Avatar
    Join Date
    Jul 2005
    Location
    Port St. Lucie, FL
    Posts
    5,445
    +1
    182
    Try to get someone to pull on the shaft, while tapping
    On the PTO bearing race. Probably just stuck on there. Use plenty of PB Blaster too.

  3. #3
    GTLaser's Avatar
    Join Date
    Aug 2009
    Location
    MD
    Posts
    330
    Quote Originally Posted by psycho rxp View Post
    Try to get someone to pull on the shaft, while tapping
    On the PTO bearing race. Probably just stuck on there. Use plenty of PB Blaster too.
    Soaking in PB now, plan to just tap it. Thanks!

  4. #4
    MSRXP's Avatar
    Join Date
    Sep 2010
    Location
    Central MS
    Posts
    5,448
    +1
    7
    Move it around in a circular motion GENTLY and pull as you are doing it. Be careful to not damage the seal at the end of the shaft. It worked for me yesterday.

  5. #5
    those things sux i had one i could never get to move till i took it out and put it in the vise and tapped it through good luck on it

  6. #6
    GTLaser's Avatar
    Join Date
    Aug 2009
    Location
    MD
    Posts
    330
    Ok that was easy, one small tap. Now my question is, does anyone use the PTO seal support tool to put the shaft back in? If not what's your method? Thanks!

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How to Re-install 2003 GTI Oil pump that was removed
    By dswelch in forum Sea Doo Open Discussion
    Replies: 1
    Last Post: 07-20-2012, 11:39 PM
  2. How to make your carbon seal water cooled
    By RXP rider in forum 4-Tec Performance
    Replies: 12
    Last Post: 03-29-2011, 08:27 PM
  3. How to re-fit jet pump & trim on kawasaki 900zxi
    By dippydi in forum Kawasaki PWC Performance (2-stroke)
    Replies: 0
    Last Post: 10-15-2010, 03:11 PM
  4. How to remove the PTO flywheel cover?
    By lt1transam in forum 2-Stroke Performance
    Replies: 7
    Last Post: 03-06-2009, 08:03 AM
  5. How to remove/install injectors...?
    By GeoRXT in forum 4-Tec Performance
    Replies: 12
    Last Post: 07-07-2007, 07:53 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •