Thread: Pump Wedge
05-11-2011, 09:49 AM #1
- Join Date
- Jun 2010
I put a pump wedge on my 2006 rxp when adjusting the steering how do i know when i am at full left and full right position
05-11-2011, 09:52 AM #2
I did it by eye. I set the steering straight and adjusted from there. That way you know that you are headed in the correct direction. It however may need small adjustments. Usually it is spot on.
05-12-2011, 12:18 AM #3
going to do a pump wedge to my ski, was the install somewhat simple?
05-12-2011, 01:37 AM #4
Yeah. Really simple. Raise VTS to full UP POSITION
Step 1: Remove venturri
Step 2: Remove wedge from packaging
Step 3: Place wedge onto pump ( it only goes one way) WITHOUT silicone
Step 4: Re-attach Venturri and attach extension rod set to 8.5".
Step 5: Attach steering extensions and Reverse Bucket extensions using red loctite
Step 6: Shave reverse bucket.
Step 7: Done
Really simple..... Nothing fancy. Shouldn't take more than a half hour to complete... Or an hour at most...
05-12-2011, 09:44 AM #5
05-12-2011, 11:23 AM #6
05-12-2011, 11:31 AM #7
05-12-2011, 12:19 PM #8
How come you do not put on silicone? Thought that was part of the process?
05-12-2011, 12:44 PM #9
05-12-2011, 01:18 PM #10
There are boss's on the steering colume that limit how far you go, If you can hit both of them right and left with no binding you should be good to go. I used the Coolant plug hole to line up my nozzle then I made sure the steering was insync with that. Good luck.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
WTB 2.5 * pump wedgeBy race24x in forum Sea Doo ClassifiedsReplies: 1Last Post: 05-30-2011, 11:48 PM
By Slow 91 in forum 2-Stroke PerformanceReplies: 7Last Post: 10-06-2009, 07:00 PM
By Chris0060 in forum 4-Tec PerformanceReplies: 13Last Post: 06-16-2009, 08:48 PM
By paramuir in forum Polaris Open DiscussionReplies: 2Last Post: 06-28-2008, 09:05 AM
By Bone1050 in forum Polaris Open DiscussionReplies: 19Last Post: 10-03-2007, 01:21 AM