Results 1 to 4 of 4
  1. #1

    msx 150 turbo water pump question

    what does the nipple off the water pump connects too, I purchased this watercraft with a blown turbo and it was half taken apart when i got it. I just can seem to figure out where it might connect too. the nipple is about a 1/4 dia


  2. #2
    Kosh's Avatar
    Join Date
    Sep 2007
    Location
    Australia
    Posts
    1,483
    +1
    83
    Welcome Jerry,

    This connects to the inner fitting on the turbocharger water cooled bearing housing.
    You should have an s shaped hose to go there. Don't worry if it looks swelled and overtightened where the clamps go they all look like that.

  3. #3
    Yes that's right I just looked, don't know how I managed to miss not installing that line when I swapped turbos. Should be interesting swapping it out now that the engine is back in place

  4. #4
    Kosh's Avatar
    Join Date
    Sep 2007
    Location
    Australia
    Posts
    1,483
    +1
    83
    Good luck with that one, I make sure it is on the turbo before I bolt the manifold up. Let me know how much swearing you do, plenty I bet.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Looking at an 04 MSX 150... Bad water pump?
    By xkursion in forum MSX/Matrix
    Replies: 2
    Last Post: 05-16-2013, 10:44 PM
  2. MSX 150 turbo issue
    By rtincher in forum MSX/Matrix
    Replies: 1
    Last Post: 09-02-2009, 12:32 PM
  3. MSX 150 Turbo
    By SeaGoat in forum Polaris Open Discussion
    Replies: 3
    Last Post: 04-29-2009, 10:46 PM
  4. MSX 150 Turbo Problem
    By mhucul in forum Polaris Open Discussion
    Replies: 4
    Last Post: 07-18-2007, 03:44 PM
  5. MSX 150 turbo question
    By Cobralyn in forum Polaris Open Discussion
    Replies: 5
    Last Post: 09-30-2006, 05:04 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •