Thread: speedfreeks bellow band
05-29-2011, 08:22 PM #1
speedfreeks bellow band
Just put the new speedfreeks bellow band on today and took the ski out to test and had wonderful results with zero cavitation. It hooks up right when you hit the throttle and doesnt move at all when in place. Erik really did a good job on this like he allways does with all his parts.The install was really easy,slides right on with a little muscle or you can put alittle oil and it should slide right on.Good job erik keep them coming!
05-29-2011, 09:21 PM #2
Ya, i put one one my ski today and hole shot cavitation was very much improved!!! Stabelizes the bellows and puts more tension on the carbon ring and hat creating a better seal. It really did create a noticeable difference on my ski and im putting 400 HP to the water off the line!!! My turbo spools veryfast and hits harder than any SC after .5 sec or so. Befor there was lots of cavition off the line id say the band cut it in half if not more!! Very easy to install. Just remove drive shaft, then remove bellows, next push-pull and wiggle bellow band into place. Then reinstall. I had mine in and ready to go in 15 mins!! EASY!! Heres some pics of the install!!
05-29-2011, 09:43 PM #3
I did mine a week or so ago... Best product beside the x-charger I have purchased....
05-29-2011, 10:14 PM #4
05-30-2011, 05:08 PM #5
- Join Date
- Aug 2007
- Sparrows Point, MD (near the Key Bridge)
How hard is it to pull the driveshaft? Do you lose oil once its out? After todays ride i need to replace my carbon seal and going to add the bellow band, just not sure of how to install everything.
05-30-2011, 05:48 PM #6
Awesome product, Works Very Well !! Worth every penny !
05-30-2011, 08:37 PM #7
Erik did it again+1 keep them coming I thank I have every SPEEDFREAKS part and love them all. My cavation is almost gone and it was horrible
05-31-2011, 08:15 PM #8
- Join Date
- Jul 2010
- Daytona Beach
is this something that would benefit a ski with just an x-charger and 4" intake?
05-31-2011, 08:21 PM #9
05-31-2011, 08:36 PM #10
I think it would benefit a stock ski... as the OEM bellow weakens over time.
Awesome piece.... made a noticeable difference for me!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Snoman in forum 4-Tec PerformanceReplies: 45Last Post: 09-07-2011, 10:03 PM
By homebrew in forum 4-Tec PerformanceReplies: 20Last Post: 07-06-2011, 01:24 PM
By tron in forum Sea Doo ClassifiedsReplies: 4Last Post: 06-23-2011, 05:50 PM
By rmk82nd in forum 4-Tec PerformanceReplies: 5Last Post: 06-04-2011, 10:05 AM