Thread: X charger slip!?!?
06-02-2011, 03:24 PM #1
X charger slip!?!?
Over the winter I installed riva clutch washers, viton seal and mcmaster carr spring washers. The slip when I put it together was 146-148 in/lbs. I left it like that thinking after a little bit it will drop down a bit. This past weekend I took it out and took it pretty easy on it. A few spped runs but the water was pretty calm. Today I decided to check the slip on it just to make sure everything was cool. Put it in the holder and checked it still 146-149 in/lbs. Is that to much? Should I lower it a bit? Maybe I am worring to much. What do you guys think?
06-02-2011, 03:50 PM #2
- Join Date
- Jul 2007
- Montgomery, AL
Leave it, 144 is where you want to be and once you start to give it some abuse it will come down.
06-02-2011, 05:03 PM #3
Your dead balls on...DO NOT adjust anything..gun it and run it.....
06-02-2011, 08:34 PM #4
06-02-2011, 09:23 PM #5
Thanks for the help guys. I will put it back on tomorrow then!!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By radeon in forum 4-Tec PerformanceReplies: 9Last Post: 08-01-2011, 09:25 PM
By tris in forum 4-Tec PerformanceReplies: 3Last Post: 06-18-2011, 11:22 AM
By boosted-delslow in forum 4-Tec PerformanceReplies: 4Last Post: 03-17-2011, 09:25 PM
By CHANDY in forum 4-Tec PerformanceReplies: 8Last Post: 06-19-2009, 08:17 AM
By ou812 in forum 4-Tec PerformanceReplies: 17Last Post: 09-11-2008, 08:38 PM