Thread: Ferrea Valves + stock ecu
06-07-2011, 12:18 AM #1
Ferrea Valves + stock ecu
I think I may have the older valves in my ski (motor was built in 05), so I will be changing out the valves shortly. I will probably get the Ferrea valves since they are a lot cheaper than the OEM valves, however I will be running the stock ecu for now. I've been reading and noticed that the lighter Ferrea Valves are more towards the higher rpm skis, but I was just wondering if these valves would be okay with just the stock ecu for now?
I will run a ecu later down the road, but not right now.
Thanks for the help guys!
06-07-2011, 06:35 AM #2
06-07-2011, 06:37 AM #3
yes, those valves will work mint for any type of condition. i have 15+ hours on my Gen1 stainless valves and not a single problem.
06-13-2011, 09:18 PM #4
I have not personally used them but I cannot see any problems that they would have. Anyone run the stock ECU with Ferra valves?
06-13-2011, 09:37 PM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By gtile04 in forum 4-Tec PerformanceReplies: 37Last Post: 10-04-2011, 08:26 AM
By 8 is enough in forum Sea Doo ClassifiedsReplies: 9Last Post: 02-19-2011, 08:45 PM
By tchies in forum Sea Doo ClassifiedsReplies: 4Last Post: 09-26-2010, 12:59 PM
By deansta in forum 4-Tec PerformanceReplies: 7Last Post: 10-31-2009, 11:21 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 6Last Post: 04-17-2008, 03:25 PM