06-13-2011, 12:50 PM #1
X-Charger Slip / 25 hours since last rebuild
I checked the slip on my charger for my T-X and found it to read out @ 8.4 ft/lbs (This was done with a recently calibrated digital Tq wrench) The charger had been sitting out of the ski for roughly a year and was tested on the bench with the counterclockwise method.
My question is I only have about 25 hours on it since the last rebuild(Jerry), so can I just shim it to get it closer to the 11.25 ft/lbs - 11.5 ft/lbs?
06-13-2011, 12:56 PM #2
06-15-2011, 09:09 AM #3
You can shim it OR go with a set of McMAster Carr washers..they are alot better than the OEM ones and will hold slip much longer...BUT first try putting your washers like this......)))()-collar-nut i bet youll see your slip come up....
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By tris in forum 4-Tec PerformanceReplies: 3Last Post: 06-18-2011, 11:22 AM
By boosted-delslow in forum 4-Tec PerformanceReplies: 4Last Post: 06-02-2011, 09:23 PM
By boosted-delslow in forum 4-Tec PerformanceReplies: 4Last Post: 03-17-2011, 09:25 PM
By TIBFIB in forum 4-Tec PerformanceReplies: 19Last Post: 07-01-2010, 08:37 AM
By ou812 in forum 4-Tec PerformanceReplies: 17Last Post: 09-11-2008, 08:38 PM