06-16-2011, 06:59 AM #1
jsut got my Riva opas full block off kit, what needs to be removed n how to install?
just got the full kit in, its used so no instructions. i looked at the opas system and see it needs a hex bit but dang its tight in there. anyone have any tips or tricks on how to remove? also what do i need to take out what can i leave in, is there a write up on how to do this anywhere?
06-16-2011, 07:15 AM #2
06-16-2011, 10:34 AM #3
ah, search button lol. thank you sir.
is there anything else i might run into on the 09 for my rxpx? nothing extra?
06-17-2011, 12:56 AM #4
I followed the link above on my '09. Pretty easy really.
06-17-2011, 07:21 AM #5
great thanks, hoping to get this done tomorrow morning as its raining and ski is out side..
how long does it take to do?
did you have to take the lower seat portion to get to the accordion tubes?
is it ok to leave them in there for a few days?
i ask cause my buddy is going to be doing FF exhaust and 4" intake on my ski the 21st at his shop and figured he can get that ish then.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By LAB69 in forum 4-Tec PerformanceReplies: 10Last Post: 05-06-2012, 09:18 PM
By billybrad in forum 4-Tec PerformanceReplies: 2Last Post: 06-26-2010, 05:42 PM
By STSPERFORMANCE in forum Sea Doo Open DiscussionReplies: 3Last Post: 04-15-2008, 06:34 PM
By Flynfox in forum Sea Doo Open DiscussionReplies: 10Last Post: 02-26-2007, 01:30 AM
By wakeborder556 in forum 4-Tec PerformanceReplies: 2Last Post: 05-09-2005, 10:29 PM