Thread: Anyone running R&D RRFPR?
06-17-2011, 11:16 AM #1
Anyone running R&D RRFPR?
I was wondering if it came as a complete kit with the FPR blockoff and a pressure gauge?
E.T. low boost wheel
Intake and ribbon removed
The ET will be boosting at 14lbs around 8500. R&D told me I would need a rrfpr for anything over 12lbs boost. I ordered a o2 adapter when I bought the ET wheel but they are on backorder for 2 weeks so I can't see my AFR until then
06-17-2011, 01:31 PM #2
ive ran my R3 with et lowboost wheel @ 8600 -8680 and afr's are ok.
if its glenn you talked to..... ive asked that guy the same question 3 times on different occasions and every time he gave me a different answear..
06-17-2011, 01:40 PM #3
I think a few guys on here that had R3/ET wheel aren't using a RRFPR. I wonder why he would give different answers each time you called...
What mods do you have Coco and what speeds? I'm debating getting this wheel or ET15.5
06-17-2011, 01:44 PM #4
- Join Date
- Sep 2007
- Gainesville, VA
I don't know what the right answer is. A lot of others have also said the ET low boost is fine with the R3, no FPR needed.
06-17-2011, 02:43 PM #5
with a low boost wheel if u have rrfpr you will most likely be running it at static.
but, it all depends on the water and air temp. where you live.
check your afr and i would recommend keeping your afr as close as possible to 11.8 to 12.0 especially when running a e1/c5 or higher wheel.
06-17-2011, 02:49 PM #6
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By PTLanza in forum 4-Tec PerformanceReplies: 11Last Post: 07-09-2011, 08:12 PM
By maxadrenaline in forum Yamaha ClassifiedsReplies: 2Last Post: 03-25-2011, 04:54 PM
By RUSH. in forum Yamaha PWC Performance (4-stroke)Replies: 8Last Post: 04-26-2010, 08:51 AM
By camar0 in forum 4-Tec PerformanceReplies: 6Last Post: 07-30-2009, 05:09 PM
By Otto J in forum 4-Tec PerformanceReplies: 3Last Post: 10-10-2008, 11:12 PM