Results 1 to 2 of 2
  1. #1

    900zxi magneto gasket

    1996 900zxi magneto cover gasket is rubber.wondering if i can use hi tack sealant to hold it in place when installing or should it be dry fit.Thanks.


  2. #2
    steve45's Avatar
    Join Date
    Feb 2008
    Location
    Texas
    Posts
    5,012
    +1
    283
    Use the rubber O-ring. Put grease on it to help hold it in place, but there will probably be a corner that slips. Put the cover on, then slide a putty knife between the housing and over to work the O-ring in place while you push the cover the rest of the way on.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 1996 Polaris SLT 780 stater-magneto / flywheel gasket needed
    By Sonix in forum Polaris Open Discussion
    Replies: 0
    Last Post: 09-05-2016, 05:13 PM
  2. Replies: 7
    Last Post: 11-19-2013, 11:14 AM
  3. 97 900zxi intake gasket question, HELP!
    By honkifyoubonk in forum Kawasaki How To & FAQs
    Replies: 2
    Last Post: 09-08-2012, 12:37 AM
  4. thinner head gasket wont go on right
    By PAINKILLER in forum 4-Tec Performance
    Replies: 12
    Last Post: 05-15-2006, 08:58 AM
  5. Rotax Racing Head Gasket good or bad
    By Jrsrxp in forum 4-Tec Performance
    Replies: 2
    Last Post: 09-06-2005, 08:33 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •