Results 1 to 8 of 8
  1. #1

    Join Date
    Dec 2009
    Location
    Meddle East
    Posts
    66

    How to use rrfpr for stock RXPX 2010 impeller

    Hello,

    I just wendring if i can use the rrfpr with stock impeller with only re-mapping ecu & Air filter ??

    RXPX 2010


  2. #2
    monaroman76's Avatar
    Join Date
    Mar 2008
    Location
    Whyalla, South Australia
    Posts
    1,979
    +1
    28
    Yes you can. Not sure why you'd want/need to.

  3. #3

    Join Date
    Dec 2009
    Location
    Meddle East
    Posts
    66
    Quote Originally Posted by monaroman76 View Post
    Yes you can. Not sure why you'd want/need to.
    to gain more rpm & speed. If it's could be???

  4. #4
    JPR's Avatar
    Join Date
    Mar 2007
    Location
    Down under
    Posts
    934
    +1
    53
    you shouldn`t need a rrfpr if the mapping was set up to the injectors.

  5. #5

    Join Date
    Dec 2009
    Location
    Meddle East
    Posts
    66
    Quote Originally Posted by jaffabas View Post
    you shouldn`t need a rrfpr if the mapping was set up to the injectors.
    So what I need if I'm installed the remapping ECU with out gaining rpm!!?

  6. #6
    monaroman76's Avatar
    Join Date
    Mar 2008
    Location
    Whyalla, South Australia
    Posts
    1,979
    +1
    28
    I'm not 100% sure what your asking, but as was already said, if your ecu is mapped to your injectors you should be fine.
    A RRFPR is only used to fine tune your requirements, it will not gain you any rpm or speed.

  7. #7
    JPR's Avatar
    Join Date
    Mar 2007
    Location
    Down under
    Posts
    934
    +1
    53
    are you asking if your prop will be good with a remaped ecu ?

  8. #8

    Join Date
    Dec 2009
    Location
    Meddle East
    Posts
    66
    Quote Originally Posted by jaffabas View Post
    are you asking if your prop will be good with a remaped ecu ?
    Yes,it's almost good. There is anther possblety??

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Looking for a finger throttle kit to use on my stock bars
    By Pikerx in forum Sea Doo Classifieds
    Replies: 7
    Last Post: 10-03-2016, 02:36 PM
  2. How to properly modify your stock intake for maximum performance step by step..
    By RUNWME in forum High Performance Watercraft Safety
    Replies: 17
    Last Post: 10-16-2008, 10:00 PM
  3. Replies: 15
    Last Post: 11-03-2007, 04:01 PM
  4. how to use primer
    By sic fish in forum Yamaha How To & FAQs
    Replies: 5
    Last Post: 05-11-2007, 05:34 PM
  5. How to use and remove JB Weld
    By Kinchyle in forum Sea Doo Open Discussion
    Replies: 8
    Last Post: 05-02-2006, 01:31 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •