99 Ultra 150.
Hadnt used it all winter and just pulled it out for a run last week.
Right away I noticed the Oil Level Warning Light was flashing. I checked the oil tank and it is 3/4 full.
I wanted to take it out so I just ignored it. Ran an entire day perfectly fine, I am now down to about 1/3-1/2 tank of oil. But the warning flashed the whole time.

Not sure where I should start...bad sensor? Bad wiring connection?
Any ideas on where to begin to get this problem sorted out?

thanks guys.

(PS. I normally post on PWCToday but I am hearing there is much more Ultra 150 help on this site so I thought I'd give it a shot.
Lets see what you guys got.)