12-08-2006, 08:50 PM #1
Instructions for installing RE bock off kit?????
Anybody know if there are installation instructions for this kit anywhere on this forum? T C
12-08-2006, 09:23 PM #2
Go to rivas site and look up the directions for their pro blocks offs use those
Last edited by ReDevilRXP; 12-08-2006 at 09:29 PM.
12-08-2006, 11:13 PM #3
Tom, i see you already have the PPG NOPAS. Just unbolt the 4 bolts holding the PPG plates on and remove them. Now, take some black RTV silicone and apply it liberally to the backside of the RE block off and stick it in place. Use the supplied bolts and washers to fasten them down. Before tightening move the blockoff as necessary to achieve the best fit and then tighten the bolts. Optionally use some of the black silicone to fill in the space between blockoff and hull.
Finnished intallation should look like this
12-08-2006, 11:20 PM #4
I must apologize guys. Race Engineering doesn't provide instructions for these things. Thanks Red Devil for posting that link. Those instructions will work perfectly.
12-09-2006, 03:13 AM #5
Thanks Red Devil and Jerry. This answers my PM, Jerry. Thanks again. T C
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By cmherrera in forum Kawasaki ProjectsReplies: 2Last Post: 02-08-2011, 08:00 AM
By repsol in forum 4-Tec PerformanceReplies: 0Last Post: 07-10-2008, 09:20 AM
By Skips313 in forum Kawasaki Tech Tips and InfoReplies: 0Last Post: 02-03-2008, 08:53 AM
By Skips313 in forum Kawasaki Tech Tips and InfoReplies: 0Last Post: 02-03-2008, 08:50 AM
By joshxp in forum Polaris Open DiscussionReplies: 4Last Post: 03-30-2007, 11:28 AM